Splashing, sandblasted and painted |
The
Barge is 16.5 meters Dutch built, hull made of iron, riveted, and probably
dated at about 1920; the steel topsides being added at later date It is a
Rietaak and was most likely used to harvest reeds when first built. The
two stars on the front indicate it was privately owned and fully paid
for in earlier days. Draft .8m and height 2.75m, so we can pass under all the bridges with room to spare. We just have to remember to let the mast down when we are traveling.
Engine water cooling pipes |
When we splashed we motored to the marina near Kampen and proceeded to rid the interior of a lot of useless junk, (well it was pretty useless to us) and find out a little about the various systems and controls.
Mercedes engine |
We cleaned out the back storage space and have
installed a 55 liter tank for the cheaper heating diesel fuel. This is
supplied to the Maritime Booster water boiler, which in turn supplies 6
radiators inside the boat, keeping the temperature pleasant throughout
with the help of a thermostat.
The
engine is a Mercedes OM 314 - 4 cylinder - 80 hp, rebuilt by Drinkwater
in Holland. There is a 300 litre diesel tank. Filters have been replaced.
Greasing the hull under the floorboards |
Old galley, corner sink |
There are three solar panels on the top deck above the wheelhouse.
Galley with fridge freezer, sink and cooker |
We
had already added a TV and were are able to get UK TV with a a satellite
dish, and we also added a Humax Freesat recording box, making it easy to get
programmes that air at times when it inconvenient for us to watch.
We
removed the floor in the storage area under the wheel house, and
painted the hull with ooey gooey grease - we had bought a 5 gallon tin of
the black gunk with us from Holland, just so that we could do this
nasty job. Mike gently heated the grease on the hob to make it runny, and I ruined several pairs
of overalls lying at inconvenient angles brushing the cooling liquid
into all the ribs and nooks and crannies.
We
repeated this throughout the boat, discovering large weights near the
bow under the bed, obviously extra ballast. The floors in the main
saloon are wood tongue and groove and it was quite a puzzle fitting all
the various lengths back together properly,
Our
next big job was to demolish the old galley, find a cooker and a
suitable household fridge freezer. The boat had a gas hob but no oven so
we got rid of that. The sink, situated in a corner, making access
extremely uncomfortable, was discarded. The small 3-way (12v; propane;
240 v) fridge now resides on the aft deck - great for beer and summer
drinks, and is occasionally used as an overflow refrigerator when we
have lots of visitors on board.
Now
we have a U-shaped galley very convenient to work in, with good
storage and a sink that one can stand in front of! We have pressure
water - hot and cold, delivered from two 300 litre stainless steel tanks
and a filter to clean up any impurities, should there be any.
Walk around bed, with storage at sides |
The propane cooker, although not big, is quite adequate with four burners and an oven.Two large propane tanks are to be found in their special compartment on the rear deck.
The
standard house fridge/freezer is a great addition - I cannot imagine
how we could manage without it, especially as it continues to work even
when we are underway, thanks to Mike installing a new 1600 watt pure
sine wave inverter.
After
some thought we realised we could add a small washing machine to our
inventory - launderettes are OK, but it is so much nicer to have ones
own machine. It took a bit of maneuvering, but we dropped a small top
loader into the gap between the new hand basin in the head and the wall
at the back. We were also able to install a nice new electric toilet.
Sadly. we had to replace the mattress on the bed. It was really comfortable, but specially constructed, and all the storage space at the sides was in accessible. as we were going to live on the boat full time, we needed the extra space.
There
was a large space in the bedroom, just the right size for a shower, and
we have a light which is linked to a pump under the floor so that the water is
pumped out. The shower is fully tiled.
The wheelhouse has had a little conversion - we can drop the solid wood table to be level with the bench seat and make a comfortable double bed for our visitors. At other times we can seat six comfortably.
No comments:
Post a Comment